Warning: mysql_pconnect() [function.mysql-pconnect]: Headers and client library minor version mismatch. Headers:50542 Library:50633 in /home/cocoon2/public_html/connections/creatif.php on line 17

Warning: session_start() [function.session-start]: Cannot send session cookie - headers already sent by (output started at /home/cocoon2/public_html/connections/creatif.php:17) in /home/cocoon2/public_html/includes/header.php on line 7

Warning: session_start() [function.session-start]: Cannot send session cache limiter - headers already sent (output started at /home/cocoon2/public_html/connections/creatif.php:17) in /home/cocoon2/public_html/includes/header.php on line 7

Warning: Cannot modify header information - headers already sent by (output started at /home/cocoon2/public_html/connections/creatif.php:17) in /home/cocoon2/public_html/index.php on line 10

Warning: Cannot modify header information - headers already sent by (output started at /home/cocoon2/public_html/connections/creatif.php:17) in /home/cocoon2/public_html/index.php on line 11
Panel Installation

Graphic Panel Installation

Step 1
Set out  pre-mitred aluminum frame and mark position on wall or ceiling; if using the deeper frame supplied for acoustic panels, assemble using cleats supplied

Step 2
Drill frame at 400mm centres and fix back to wall OR use VHB tape if substrate is clean, smooth and non-porous

Step 3
If installing acoustic material, simply peel off self-adhesive backing, position and press firmly into place

Step 4
Offer up the fabric and start in the top left corner by turning the silicone bead over by 90degrees and pushing home a 75mm length into the horizontal and vertical perimeter grooves in the aluminium frame

Step 5
Repeat this process in each corner

Step 6
Go to the mid-point on each side of the frame and push home a 200mm strip of silicone bead

 

Step 7
Work your way along between mid-points and corners taking care not to stretch or compress the silicone bead.

Step 8
If the fabric is too slack you may have stretched the silicone bead in which case you should remove the fabric, let it contract and then start again. Alternatively, double over the bead and fabric and trim off the excess in the corners

Step 9
If the fabric is very taut you may have to grip the silicone bead and fabric and gently tug to slightly stretch the fabric so you can push the bead in; alternatively store the fabric in a cold room overnight or dampen with water with an atomizer to get the fabric to relax

Step 10
Using the reverse (blunt) edge of the Stanley knife, tuck in any stray fabric to tidy the corners, taking care not to slice the fabric